Masimo Radical Signal Extraction Manual do Operador descarregar pdf (Página 67)

Radical Signal Extraction Pulse Oximeter Operator’s Manual 57

service/maintenance

introduction

This chapter covers how to test the operation of the Radical and the SatShare interface,

how to properly clean the Radical pulse oximeter, how to recharge and replace the

batteries, how to replace the fuses, and how to obtain service.

Under normal operation, no internal adjustment or recalibration is required. Safety tests

and internal adjustments should be done by qualified personnel only. Safety checks should

be performed at regular intervals or in accordance with local and governmental regulations.

cleaning

To clean the display panel, use a cotton swab moistened with 70% isopropyl alcohol and

gently wipe the panel.

To clean the outer surface of the oximeter, use a soft cloth dampened with a mild soap and

water. Do not allow liquids to enter the interior of the instrument.

CAUTIONS:

■

DO NOT AUTOCLAVE, PRESSURE STERILIZE, OR GAS STERILIZE THIS

OXIMETER.

■

DO NOT SOAK OR IMMERSE THE MONITOR IN ANY LIQUID.

■

USE THE CLEANING SOLUTION SPARINGLY. EXCESSIVE SOLUTION CAN FLOW

INTO THE MONITOR AND CAUSE DAMAGE TO INTERNAL COMPONENTS.

■

DO NOT TOUCH, PRESS, OR RUB THE DISPLAY PANELS WITH ABRASIVE

CLEANING COMPOUNDS, INSTRUMENTS, BRUSHES, ROUGH-SURFACE

MATERIALS, OR BRING THEM INTO CONTACT WITH ANYTHING THAT COULD

SCRATCH THE PANEL.

■

DO NOT USE PETROLEUM-BASED OR ACETONE SOLUTIONS, OR OTHER

HARSH SOLVENTS, TO CLEAN THE OXIMETER. THESE SUBSTANCES ATTACK

THE DEVICE’S MATERIALS AND DEVICE FAILURE CAN RESULT.

Refer to Section 8, Cleaning and Reuse of Masimo LNOP Sensors for cleaning instructions

of the sensor.

WARNING: ELECTRICAL SHOCK AND FLAMMABILITY HAZARD - BEFORE

CLEANING THE OXIMETER, ALWAYS TURN IT OFF AND DISCONNECT THE

POWER CORD FROM THE AC POWER SUPPLY.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 77 78

Sem comentários

Masimo Radical Signal Extraction Manual do Operador Página 67